allowing for optimal levels of performance

Rubin 2 sanding belts range from P40 for rough surface finishes or to prep for higher grits up to P150 grit abrasives for finish sanding on softer woods

Chip exhaust for efficient removal of metal swarf

the HAMMERVAC provides filtration for up to 160 holes on a single charge

Cutter Conduit 3mm To 42mm

Nibbler Punch & Die Set 48440272 by Milwaukee Guide Rail Adjustable Angle Stop allowing for optimal levels ofThe Nibbler Punch & Die Set is to be used with the M12 FUEL 16 Gauge Nibbler Tool. The accessory punch and die is the portion of the tool that performs the cutting functionality and should be routinely replaced every 4 6 months. This accessory is good for cutting thin sheet metal and corrugated materials. Features For use with M12 FUEL 16 Gauge Nibbler Tool Tool Free accessory change Specifications Material: Metal Length: 76. 2mm Width: 17. 78mm